Application Planning; Installation Site - Eizo SCD 19102 Instruction Manual

High end 19” color and gray scale flat panel display

Hide thumbs Also See for SCD 19102:

Table of Contents

Application planning

4.1

Provide adequate ventilation

Ventilation slots are located on the rear of the housing.

The distance at the rear must be at least 10 cm from a wall or 15 cm from other units.

Observe the permissible ambient temperature range

The unit must not be operated outside the permissible ambient temperature range.

Desktop installation

If the SCD / SMD 19102 is mounted on a stand, it must be positioned on a hard, horizontal

surface.

Avoid reflections on the screen

The display has an anti-glare surface which is only effective with a clean, grease-free

screen.

The SCD / SMD 19102 CP display includes an optically coated protective glass pane, which

is well suited for use in a germ-free environment when cleaning agents are used.

If the screen surface is dirty, clean it using a suitable microfiber cloth.

Please note the additional cleaning instructions, see the section "Service and

Maintenance" (Page 73).

The display should be positioned so that reflections of lights, windows, furniture with shiny

surfaces or light-colored walls do not appear on the screen.

In order to reduce mirroring on the unit, only use non-dazzling reflector lights for the ceiling

lighting.

Change of environment

If the unit is brought into a warm environment from a cold one, condensation may form in the

unit. The unit should not be switched on until all the condensed water has evaporated,

including that inside the unit. This may take several hours, depending on the conditions.

Table of Contents