Selection Of The Tv Standard (Optional, It Is Possible In The Viatv Portal As Well); Selection Of The Video Format For Hd Outputs - Motorola VIP 1910 Installation Instructions And Manual

3.1 Selection of the TV standard (optional, it is possible in the viaTV Portal
as well)
Start with the selection of the so-called television standard (system) format. Press the right cursor arrow
and the "Video" item will undo into the "TV System Selection" and the "Video Output Selection" items
(the figure on the left). Press the arrow once more and the option of a change between the PAL and
NTSC picture formats becomes activated (the figure on the right). The format is selected using the up and
down arrows.
The PAL refers to a standard used mainly in Europe, while the NTSC refers to a standard used in
the USA. Unless you have some special reason for selecting NTSC, select PAL, (if there is
a selection from several PAL systems (in case of later models of the set-top box, select the one,
which
is supported by your television set, see the instruction manual for the television set).
As soon as you have found, using arrows, the picture format you prefer, activate it by pressing the OK
button.
We recommend performing the entire setting in the viaTV Portal (as mentioned below).

3.2 Selection of the video format for HD outputs

The selection of the video format depends on the possibilities of your television set and on the type
of video connectors you use. The set-top box has three connectors – which corresponds with the three
columns in the menu below – HDMI, Component and SCART. The set-top box may be set in five
different states (combinations of states) corresponding with five lines mentioned below, among which you
perform your selection. For you, the current items in the column (of the connector), which you wish to use,
are relevant.
viaTV_STBmanual_M1910_EN.doc Page 6 (Total 38)