Kreatel Ip-Stb Boot Progress Indicators; Portal Control - Remote Control - Motorola VIP1500 User Manual

Table of Contents

Advertisement

Note:
The selection should match the type of cable you are using, i.e. if using a S-Video
cable the S-Video selection should be ON.
Note:
In addition to RGB, it's also possible to get S-Video or Composite video from
the SCART connector. In this case a special SCART to SVideo or SCART to composite
cable is required.
5. When the correct video signal is selected, the TV-image should be stable without flicker
or disturbances.
6. Color system Use the Left and Right main cursor buttons to toggle between PAL and
NTSC. (Remote control is displayed in the picture 1.3.)
7. When the Color system and Video output are set, it is possible to use:
• OK button - to leave the dialog and save all changes made
• STOP button - to leave the dialog without saving any changes
8. After saving the changes, the Kreatel IP-STB will be rebooted. The following dialog will
be shown for two seconds regardless if any changes have been made or not:
1.4

Kreatel IP-STB boot progress indicators

During the booting process, the Kreatel IP-STB displays a number of coloured dots on the
screen. These may be used for error handling. Five dots are available, and each of these may
either be dark grey, steady red, steady yellow, blinking yellow or steady green. The dark grey
colour is used to represent an inactive state. Colors meaning are described in table 1.1.
1.5
Portal control – Remote control
Picture of the remote control, which is enclosed for STB VIP1500 and VIP1700 manufactured
by Motorola, is displayed in the following picture together with the information about the basic
control elements:
Figure 1.2: Kreatel STB – Rebooting from Setup
DocID:
STBGUIDE
Security level:
public
Page:
3 / 26
Revision:
40127 /bobek
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vip1700

Table of Contents