Driven Pulley Axle Support Bearing Assembly - PIAGGIO 500 cc Service Manual

- Hold the driven pulley axle support by means of the
specific tool 001467Y002.
- Remove the bearing by means of the specific tool.
N.B.: If the bearing decay has caused the external race
to lose strength, replace the driven pulley axle support.
Specific tools:
Bell
Handle
28x30 mm adapter
17 mm guide

Driven pulley axle support bearing assembly

- Heat the driven pulley axle support with the thermal
gun.
Specific tool:
Air heater
- Fit the bearing on the specific tool. Grease it to
prevent it from coming out.
- Refit the new bearing by means of the specific tool.
- Refit the snap ring.
Specific tools:
Handle for drifts
37x40 mm adapter
17 mm guide
- Fit the driven pulley axle support and tighten the two
lower screws.
001467Y002
020376Y
020375Y
020439Y
020151Y
020376Y
020358Y
020439Y
Automatic transmission
05_038
05_039
05_040
05_048
3 - 13
3