Clutch Disassembly; Pins Stop Collar; Specific Tools; Automatic Transmission - PIAGGIO 500 cc Service Manual

Automatic transmission

Clutch disassembly

- Remove the clutch and driven pulley by means of the
specific tool;
- Prepare the tool with the pins screwed in the «E»
position on the internal side;
- Assemble the driven pulley assembly on the tool and
insert the pins in the ventilation holes;
- Bring the rear stop screw in contact with the fixed
driven pulley, as shown in the figure.
Warning
- Put the tool in a vice firmly. Do not
overtighten the rear screw to avoid buckling the tool.
- Remove the fixing ring nut with the specific spanner
of 55 mm.
- Unloose the tool screw and dismount the driven
pulley, clutch, spring with sheath assembly

Specific tools:

Driven pulley spring compressor
55 mm spanner
Ring

Pins stop collar

- Remove the collar by means of 2 screwdrivers.
- Remove the 4 guide pins.
- Remove the mobile driven half pulley.
3 - 6
020444Y
020444Y009
020444Y010
05_019
05_020
05_021