PIAGGIO 500 cc Service Manual page 101

Driving shaft crankcase
- Remove the bearing from the half crankcase trans-
mission side by means of the specific tool.
Specific tool:
Pliers
Bell
- Before assembling a new bearing, heat the half
crankcase flywheel side by means of the specific tool
- Put the half crankcase on a wooden base
Specific tool:
Heater
- Fit a new bearing on the specific tool after having
greased the fitting slot
- Assemble the new bearing on the half crankcase by
means of the specific tool.
N.B.: If a bearing with a plastic cage is used, position the
balls so that they face the crankcase inner side.
Specific tool:
Punch handle
Adapter 42x47 mm
17 mm guide
- Assemble the snap ring.
8 - 8
001467Y008
001467Y007
020151Y
020376Y
020359Y
020439Y
05_263
05_264
05_265
05_261