Replacing The Power Supply - Gateway Tower User Manual

6
Install the new card into the add-in slot.
You can slightly seesaw the card end-to-end to help insert the card, but
do not bend the card sideways.
7
Push the add-in card retention cover inward.
8
If you disconnected any cables, reconnect the add-in card cables using your
notes from
instructions.
9
Close the case by following the instructions in
page 266.
10
See the documentation that came with the card for any special software
installation instructions.

Replacing the power supply

To replace a power supply:
1
Identify your computer case style. For more information, see
your computer case style" on page
2
Open the case by following the instructions in
page 263.
3
Remove the front bezel by following the instructions in
replacing a CD, DVD, or diskette drive" on page
4
Disconnect the power supply cables from all components (such as, hard
drives, CD/DVD/Recordable drives, and the system board), noting their
locations and orientation. (You will reconnect the cables after you install
the new power supply.)
Step 3. See the add-in card documentation for further
www.gateway.com
Upgrading the Gateway New Micro Tower Case
"Closing the case" on
220.
"Opening the case" on
267.
"Identifying
"Adding or
277