THOMSON SHDSL Manual page 40

4| Configuring and Operating the SHDSL Interface
force-tcpam16
force-tcpam32
lineprobing
simulate-lp
vendor-specific
The profile type is CO:
annex: this parameter indicates which regional requirements are taken into account:
af: the regional requirements of ITU-T G.991.2 Annex A&F (North America) are used.
bg: the regional requirements of ITU-T G.991.2 Annex B&G (Europe) are used.
minbw: this is the minimum bandwidth at which the DSL modem should initialize.
maxbw: this is the maximum bandwidth at which the DSL modem should initialize.
linecode: this parameter indicates the line coding used for data transfer:
16-tcpam
32-tcpam
auto
margincurrent: the current noise margin value, expressed in dB.
The noise margin indicates the amount that the noise may increase (and as a consequence the SNR
may decrease), but at which the modem must remain synchronized.
marginworst: the worst noise margin value, expressed in dB.
margincurrentenable: this parameter is used to enable or disable the use of the current noise margin
value.
marginworstenable: this parameter is used to enable or disable the use of the worst noise margin
value.
monitoring: this parameter is used to enable or disable Transmission Quality (SNR) monitoring.
The profile type can not be changed with this command. If you want to change the profile type,
delete the profile and create a new one with the correct profile type.
The configuration of a DSL profile can not be modified if it is used by an attached DSL interface. In
this case, the DSL interface must be
34
detached first.
E-DOC-CTC-20080313-0001 v2.0