THOMSON SHDSL Manual page 34

4| Configuring and Operating the SHDSL Interface
:xdsl ifadd
To create a new DSL interface, execute the command
Following two parameters must be specified:
name: the name of the new DSL interface.
profile: the name of a DSL profile that was created in advance.
For example, create a new DSL interface:
=>:xdsl ifadd name=dsl0 profile=test-co
As soon as the new DSL interface is created, i.e. the interface name and profile name are specified, the
configuration parameters are set to default values, which depend on the profile type of the DSL interface. For
more information on the default configuration, see
The maximum number of DSL interfaces is limited. For more information, see
capabilities and limits" on page
:xdsl ifattach
To activate a DSL interface, execute the command
interface, the G.Hs exchange starts.
The following parameter must be specified:
name: the name of the DSL interface to be activated.
For example, activate a DSL interface as follows:
=>:xdsl ifattach name=dsl0
:xdsl ifconfig
To configure a DSL interface, execute the command :
it must be set to detach mode.
The following parameter must be specified:
name: the name of the DSL interface to be configured.
Optionally, following parameters can be specified:
ul-mode: the Transmission Convergence (TC) layer. Two values are possible:
atm: Asynchronous Transfer Mode. This is the default value.
efm: Ethernet in the First Mile.
In case of previous releases, a device reboot may be necessary to successfully change the
TC-layer from ATM to EFM (or vice versa).
wire-mode: the DSL wire configuration of the device. The possible values depend on the profile type of
the DSL interface:
If the profile type is CPE, the parameter can be set to 1pair, ..., mpair and auto.
The default value is auto.
If the profile type is CO, the parameter can be set to 1pair, ..., mpair.
The default value is mpair.
28
:xdsl ifadd
" :xdsl iflist" on page
13.
:xdsl ifattach
xdsl ifconfig
.
29.
" Product
. Immediately after activating a DSL
. Prior to configuring a DSL interface,
E-DOC-CTC-20080313-0001 v2.0