THOMSON SHDSL Manual page 28

4| Configuring and Operating the SHDSL Interface
Configure the CPE
Configure a Thomson SHDSL device in CPE mode as follows:
Configure the prompt to easily identify the device that is being configured:
{Administrator}=>:env set var=PS1 value="%env(Usr_Prompt)%groupx[]=>"
=>:env set var=Usr_Prompt value={TG628s-CPE}
Configure the IP address as follows:
{TG628s-CPE}=>:ip ipadd intf=lan1 addr=10.0.0.10 netmask=24 addroute=enabled
Save the configuration:
{TG628s-CPE}=>:saveall
By default, a Thomson SHDSL device is configured in CPE mode. No extra configuration of SHDSL
is required.
22
E-DOC-CTC-20080313-0001 v2.0