THOMSON SHDSL Manual page 27

4| Configuring and Operating the SHDSL Interface
Remove the factory default interfaces and settings that you do not need for the configuration:
{Administrator}=>:ip ifdelete intf=dmz1
{Administrator}=>:ip ifdelete intf=guest1
{Administrator}=>:ip ifdelete intf=wan1
{Administrator}=>:ip ipdelete addr=10.0.0.138
{Administrator}=>:ip ipdelete addr=192.168.1.254
{Administrator}=>:eth flush
{Administrator}=>:eth vlan flush
{Administrator}=>:eth bridge ifdelete intf=Internet_8_35
{Administrator}=>:eth bridge ifdelete intf=Internet_0_35
{Administrator}=>:atm ifdelete intf=atm_8_35
{Administrator}=>:atm ifdelete intf=atm_0_35
{Administrator}=>:atm phonebook delete name atm_pvc_8_35
{Administrator}=>:atm phonebook delete name=atm_pvc_0_35
Disable the broadcast filter on the bridge. This way, broadcasts (e.g. ARP requests) that arrive on a WAN
interface are correctly received by the SHDSL device (and not dropped):
{Administrator}=>:eth bridge config filter=none
Make these changes permanent. This will be the starting point for our configuration:
{Administrator}=>:saveall
Configure the CO
Configure a Thomson SHDSL device in CO mode as follows:
Configure the prompt to easily identify the device that is being configured:
{Administrator}=>:env set var=PS1 value="%env(Usr_Prompt)%groupx[]=>"
=>:env set var=Usr_Prompt value={TG628s-CO}
To configure SHDSL, execute following CLI commands:
{TG628s-CO}=>:xdsl ifdetach name=dsl0
{TG628s-CO}=>:xdsl ifdelete name=dsl0
{TG628s-CO}=>:xdsl ifadd name=dsl0 profile=def-co
{TG628s-CO}=>:xdsl add name=dsl0 wirepair=link0
{TG628s-CO}=>:xdsl add name=dsl0 wirepair=link1
{TG628s-CO}=>:xdsl add name=dsl0 wirepair=link2
{TG628s-CO}=>:xdsl add name=dsl0 wirepair=link3
{TG628s-CO}=>:xdsl ifattach name=dsl0
Configure the IP address as follows:
{TG628s-CO}=>:ip ipadd intf=lan1 addr=10.0.0.20 netmask=24 addroute=enabled
Save the configuration:
{TG628s-CO}=>:saveall
E-DOC-CTC-20080313-0001 v2.0
21