Assigning Names To The Sources - JVC KD-LX555R Instructions Manual

Assigning names to the
sources
You can assign names to CDs and the external
component. After assigning a name, it will appear
on the display when you select the source.
Sources
CDs* and
CD changer*
External component Up to 10 characters
* You cannot assign a name to a CD Text and an MP3
disc.
1
Select a source you want to assign a
name to.
ATT
SOURCE
2
Press and hold SEL (S) for more
than 2 seconds while pressing
DISP (D).
DISP
SEL
D
S
Ex.: When you select the CD as the source.
Ex.: When you select the external component as
the source.
Maximum number of
the characters
Up to 32 characters (up
to 40 discs)
3
Select the character set you want
while " " is flashing.
Each time you press the button,
DISP
D
the character set changes as
follows:
Capital letter ( )
Numbers and symbols ( )
4
Select a character.
• See "Available
5
Move the cursor to the next (or
previous) character position.
6
Repeat steps 3 to 5 until you finish
entering the name.
7
Press the button while the last
selected character is flashing.
The input name is stored in
SEL
S
memory.
To erase the entered characters
Insert spaces using the same procedure
described above.
Notes:
• When you try to assign a name to the 41st disc,
"NAME FULL" appears on the display. (In this
case, delete unwanted names before assignment.)
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit.
Small letter ( )
characters" on page 37.
35