Assigning Names To The Sources - JVC kd-lx100 Instructions Manual

Assigning names to the
sources
You can assign names to station frequencies and
CDs. After assigning a name, it will appear on
the display when you select the source.
Sources
Station frequencies Up to 10 characters (up to
CDs * and
CD changer *
* You cannot assign a name to a CD Text.
1
Select a source you want to assign a
name to.
2
Press and hold SEL (select) for more
than 2 seconds while pressing DISP.
When you select a station frequency as the
source:
When you select the CD as the source:
22
Maximum number of the
characters
30 station frequencies
including both FM and AM)
Up to 32 characters (up to
40 discs)
3
Select a character.
About the available characters, see below.
4
Move the cursor to the next (or
previous) character position.
5
Repeat steps 3 and 4 until you finish
inputting the name.
6
Press the button while the last
selected character is flashing.
The input name is stored in memory.
To erase the input characters
Insert spaces using the same procedure
described above.
Available characters
A B C D E
K L M N O
U V W X Y
4 5 6 7 8
space
Notes:
• When you try to assign a name to the 41st disc,
"NAME FULL" appears on the display. (In this
case, delete unwanted names before assignment.)
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs
in this unit.
F G H I J
P Q R S T
Z 0 1 2 3
9
– / <
>