Tuning In To A Preset Dab Service - JVC KD-LX555R Instructions Manual

4
Press and hold the number button
(in this example, 1) you want to store
the selected service into for more
than 2 seconds.
EQ
1 7
"PI" flashes for a few seconds.
5
Repeat the above procedure to store
other DAB services into other preset
numbers.
Notes:
• You can only preset primary DAB services. If you
store a secondary service, its primary service will
be stored instead.
• A previously preset DAB service is erased when a
new DAB service is stored in the same preset
number.
• Preset DAB services are erased when the power
supply to the memory circuit is interrupted (for
example, during battery replacement). If this
occurs, preset the DAB services again.
Tuning in to a preset DAB
service
You can easily tune in to a preset DAB service.
Remember that you must store services first. If
you have not stored them yet, see page 44.
1
Select the DAB tuner (DAB1 – 3).
ATT 1 Press SOURCE ATT to select
SOURCE
DAB tuner as the source.
2 If necessary, press and hold
BAND
MODE
BAND MODE (M) repeatedly
M
to select the DAB band
number (DAB1, DAB2 or
DAB3).
Each time you press and hold the button,
the DAB band changes as follows:
D1
(DAB1)
2
Select the number (1 – 6) for the
preset DAB service (primary) you
want.
EQ MONO
7 8
1 2 3
Note:
If the selected primary service has some secondary
services, pressing the same number button repeatedly
will tune in to the secondary services.
D2 D3
(DAB2) (DAB3)
INT RPT RND
9 11 6 12
10 5
45