Removing A Comm Channel; Changing Or Replacing A Saved Comm Channel - Garmin NavComm SL30 User Manual

Advanced Operation
1. While in Comm mode, press
display will show "store as" with a flashing cursor
at the first character of the name.
2. Turn the
3. Turn the
position.
4. After you turn the
past the fourth character, three underscores at the end
of the line will flash.
5. Turn the
6. Press
you do not want to save the frequency.

Removing a Comm channel

You may only remove channels stored in the User list.
1. In Comm mode, press
2. Turn the
SMALL
3. Press
the display.
4. Press
press

Changing or Replacing a Saved Comm Channel

Channels you have saved in the User list may be changed
or updated by replacing the frequency, but keeping the
same name and type.
1. Note the name of the channel you want to change. You
are going to use the same name and type for a new
channel.
2. Turn the
desired Standby frequency.
3. Press
"store as" with a flashing cursor at the first
character of the name.
8
119.10 s124.55
SMALL
knob to choose the desired character.
LARGE
knob to move to the next character
LARGE
SMALL
knob to choose the desired type.
ENT
after making your selections. Press
LARGE
knob to the User list and then turn the
knob to the desired channel.
SEL
. "Remove?" will flash on the right side of
119.10 s124.55
ENT
to remove the channel from the User list or
SEL
to exit without making changes.
LARGE
and
ENT
. The right side of the display will show
ENT
. The right side of the
store as _
knob one position clockwise
SEL
.
SLE ats Remove?
SMALL
knobs to display the
SEL
if