Introduction; General Instructions - Camus Hydronics MFH060 Installation, Operation And Service Manual

Camus Hydronics proudly introduces its MicoFlame series of water heaters / hydronic boilers. These gas
burning appliances are thoughtfully designed for easy operation and maintenance. We are confident that
you will come to appreciate the benefits of our product.
1.

GENERAL INSTRUCTIONS

The installation of this heater must conform to the requirements of the authority having jurisdiction or, in
the absence of such requirements, to the latest or current as amended National Fuel Gas Code, ANSI
Z223.1 or CAN/CGA B149 Installation Codes. All electrical wiring must be done in accordance with the
requirements of the authority having jurisdiction or, in the absence of such requirements, with the National
Electrical Code, ANSI/NFPA 70 or the Canadian Electrical Code Part I, CSA C22.1 Electrical Code.
Vent installations must be in accordance with Part 7, Venting of Equipment, of the latest edition or the
current as amended National Fuel Gas Code, ANSI Z223.1, or Section 7, Venting Systems and Air
Supply for Appliances, of the CAN. CGA B149, Installation Codes and applicable provisions of the local
building codes.
When required by the authority having jurisdiction, the installation must conform to the Standard for
Controls and Safety Devices for Automatically Fired Boilers, ANSI/ASME CSD-1.
The qualified installer shall instruct the end user in the safe and correct operation of this appliance and
shall ensure that the heater is in safe working order prior to leaving the job site.
WARRANTY:
Factory warranty shall apply only when the boiler is installed in accordance with local
plumbing and building codes, ordinances and regulations, the printed instructions
provided with it and good industry practices.
Excessive water hardness causing a lime build-up in the copper coils or tubes is not a
fault of the boiler. Consult the factory for recommendations for use in hard water areas.
Damage to the heat exchanger as a result of scaling or corrosive water conditions in
non-warrantable.
Using or storing corrosive chemicals in the vicinity of this boiler can rapidly attack the
copper tubes and coils and voids warranty.
The primary heat exchanger of this boiler is intended to operate under non-condensing
conditions. Inlet temperatures must be maintained at 110 ° ° ° ° F or higher. Warranty is void if
the primary heat exchanger is allowed to operate in condensing mode.
Damage caused by freezing or dry firing voids warranty.
This boiler is not to be used for temporary heating of buildings under construction.

INTRODUCTION

2