Record Setup; Osd Position; Osd Position Setup; Quality & Frame Rate Setup - Digimerge DH100 Series Instruction Manual

RECORD SETUP

Use the Record menu to configure
system recording settings.
To configure hard drive recording mode:
1. Beside HDD Full drop-down menu, select
Overwrite or Stop.
• Overwrite: When the hard drive is full, the
hard drive will erase the oldest footage, and
begin recording again in a loop (first in first
out).
• Stop: The system stops recording when the
hard drive is full.

OSD Position

To configure the OSD X&Y axis:
1. Beside OSD position X and OSD position Y,
enter the desired screen co-ordinates.
2. Right-click and click Yes to save your
settings.

OSD Position Setup

The OSD position setup allows you to change
where the time and date appears.
To configure the OSD Position:
1. Click the OSD Position Setup button.
2. Drag the time/date to the desired location.
3. Right-click to exit. Right-click again and
click Yes to save your changes.
Select Overwrite or Stop
Quality & Frame Rate Setup
To adjust the recording quality and frame
rate:
1. Click the Quality & Frame Rate Setup
button.
2. Configure the following:
• No.: Select the camera number you wish
to configure.
• View Normal: Select the checkbox to
configure how the system records during
normal recording.
• View Event: Select the checkbox to
configure how the system records during
event recording.
• Resolution: Select recording resolution.
Select from CIF, FIELD, or FRAME.
• Quality: Configure the recording quality.
Select from LOW, MIDDLE, HIGH, SUPER
or ULTRA.
• F/S (frames per second): Select the system
frame rate speed.
• Auto button: Click the Auto button for the
system to optimize the frames allocated to
recording.
3. Right-click and click Yes to save your
settings.
Using the Main Menu
27