JVC GET0602-001A Instruction Manual page 145

A
Connecting the parking brake lead
Parking brake
B
Connecting the reverse gear signal lead (for rear view camera)
Locate the reverse lamp lead in the trunk.
Purple with white stripe
C
Connecting the external amplifier and/or subwoofer
You can connect an amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
Rear speakers
JVC Amplifier
*
1 Not supplied for this unit.
* 2 Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car's chassis using shorter and thicker cords?
• This unit becomes hot.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• This unit does not work at all.
* Have you reset your unit?
Crimp connector
Parking brake switch (inside the car)
Extension lead
To car battery
Remote lead * 1
Remote lead (blue with white stripe)
* 1
Signal cord
*
1
Crimp connector * 1
To reverse lamp
Reverse lamp lead
Y-connector * 1
Only for KW-AVX726/KW-AVX724
Front speakers
3
Parking brake lead (light green)
To metallic body or chassis of the car
Reverse lamps
To the remote lead of other equipment or automatic antenna if any
Audio cord * 1
JVC Amplifier
Subwoofer