Dell 3110cn Service Manual page 292

Removal 11 OPERATOR PANEL (PL1.2.97)
Steps 1 through 5 are for reference. Before removing this component, check that Steps 1 and 2 have
been performed.
When removing the OPERATOR PANEL only, perform Steps 1, 5, 6, 7, 8, and 9.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 12)
4) Remove the RIGHT COVER. (Removal 13)
5) Remove the CHUTE ASSY EXIT OUT. (Removal 10)
9)-2
9)-1
9)-1
6) Remove the one screw (silver, tap, 8mm) that fixes the BRACKET HARNESS (PL1.2.34) to
the FRONT COVER.
7) Remove the BRACKET HARNESS from the FRONT COVER.
8) Release the clamp that fixes the core of the HARNESS ASSY OPEPANE, and then disengage
the connector (P/J220) of the OPERATOR PANEL (PL1.2.16).
When performing the step described below, take care not to drop or damage the OPERA-
TOR PANEL.
9) Remove the OPERATOR PANEL by releasing the four hooks that fix the OPERATOR PANEL
to the printer.
Continues to the next page.
Version 3 2007.03.15
9)-1
9)-1
Chapter 3 Removal and Replacement Procedures (RRPs)
3 - 18
8)
6)
7)
Kmy03014KA