Removal 27 Shield Assy Ess (Reference Only) - Dell 3110cn Service Manual

Removal 27 SHIELD ASSY ESS (REFERENCE ONLY)

Steps 1 through 4 are for reference. Before removing this component, check that Steps 1 through 4
have been performed.
1) Open the FRONT COVER (PL1.2.1).
2) Remove the FUSER. (Removal 8)
3) Remove the REAR COVER. (Removal 12)
4) Remove the LEFT COVER. (Removal 22)
5) Remove the seven screws (silver, 6mm) that fix the SHIELD ASSY ESS to the printer.
When performing the step described below, take care not to move the SHIELD ASSY
ESS from the printer too far because they are connected with the harness.
6) Release the lug on the SHIELD ASSY ESS from the notch on the printer by moving the
SHIELD ASSY ESS to the arrow direction, and then remove the SHIELD ASSY ESS from the
printer.
Go to the next removal step:
Removal 28 HUMIDITY SENSOR (PL9.1.19) or Removal 29 MACHINE CONTROL UNIT
(PL9.1.20)
Version 3 2007.03.15
Chapter 3 Removal and Replacement Procedures (RRPs)
5)
5)
5)
3 - 50
5)
6)-1
5)
5)
6)-2
5)
Kmy03040KC