Robertshaw RS4110 Installation Manual page 10

Pop-Up Wizard
The Wizard routine will display factory default settings. Each setting will
display for ten seconds. Use the
setting. Settings that are not changed will operate with the values that
are displayed. To fast forward through the Wizard, press Edit Schedule.
The Wizard can be exited by pressing Start/Stop Schedule. This will
save the settings and place the thermostat into operation.
Use this chart to write down the desired settings before applying power.
Settings may vary by model.
Displayed Details
SCAL choose °F or °C
CLOC choose 12 or 24 hour
LITE y = always on, n = off
DIFF differential, set between 0.5 to 3.0 °F
or 0.5 to 1.5 °C
DIF2 2nd stage differential,
added to first stage differential
DLY2 2nd stage delay, in minutes
DLY3 3rd stage delay, in minutes
AUTO auto changeover enable
DEDB auto changeover deadband
in degrees
HI heat setting limit in degrees
LO cool setting limit in degrees
VAC HEAT vacation heat setpoint in degrees
VAC COOL vacation cool setpoint in degrees
CHECK check filter timer in hours
CYCL compressor short cycle delay in minutes
CAL calibration offset in degrees
After the Wizard has configured the thermostat, the settings can be
edited by pressing
change settings.
Factory settings that have not been changed will use the default settings
for operation.
or
and simultaneously. This will allow you to
10
buttons to change the
Default Change To
°F
12
y
1 °F
2 °F
20
20
y
3 °F
90 °F
45 °F
62 °F
85 °F
n or OFF
5
0
_______
_______
_______
_______
_______
_______
_______
_______
_______
_______
_______
_______
_______
_______
_______
_______