Serial Interface, Configuration - SATO GL408e Programming Reference Manual

SERIAL INTERFACE, CONFIGURATION

FUNCTION Specifies the programming configuration of the serial interface.
FORMAT
<ESC>I2abcde
Place in separate data stream sent to the printer.
EXAMPLE
<ESC>A
<ESC>I230011
<ESC>Z
OUTPUT
This command does not result in printer output.
NOTES
The settings are stored in the EEPROM by this command and they will remain in
effect until a new <ESC>I2 command is received. Cycling power will not have an
effect on these settings.
To change the value stored in the EEPROM, use the <ESC>PC Printer Setting
command or use the Printer Setting Utility program contained on the CDROM shipped
with the printer.
All command parameters must be present in the data stream sent to the printer.
Selecting X-On/X-Off, Bi-Com3 or Bi-Com4 will automatically place the printer in the
Multi Buffer mode.
SATO GL4xxe SBPL Programming Reference
a = Baud rate
0: 9600 bps
1: 9200 bps
2: 8400 bps
3: 57600 bps
b = Data bits
0: 8
1: 7
c = Parity
0: No parity
1: Odd parity
2: Even parity
d = Stop bits
0: 1 Stop bit
1: 2 Stop bits
e = 0: Single item buffer
1: Multi item buffer
2: X-On/X-Off Flow control
3: Bi-Com 4
4: Bi-Com 3
Unit 4: Standard Command Codes
Page 4-60