Brother DCP-9055CDN Service Manual page 66

Error message
Replace Belt Unit
Parts
Drum Unit
Fuser Unit
Laser Unit
PF Kit MP
PF Kit 1
PF Kit 2
Replace Toner
Replace WT Box
Scan Unable XX
Self-Diagnostic
Short paper
Size Error
Size Error DX
Description
Belt unit is at the end of life.
Drum unit is at the end of life.
Fuser unit is at the end of life.
Laser unit is at the end of life.
MP paper feeding kit is at the end of life.
Paper feeding kit1 is at the end of life.
Paper feeding kit2 is at the end of life.
Each toner cartridge reached the end of
life.
The color toner reached the end of life
during printing.
Waste toner box full. (The sensor detected
that the waste toner became full.)
Some kind of scanning error.
Fuser unit error.
(After the error code 58 occurred, a failure
in the fuser unit is detected again upon
start-up.)
It was detected that the length of the paper
under printing was less than the specified
value.
A paper size, which is not supported by the
paper tray 1, is specified in the paper size
of the data.
A paper size, which is not supported by the
paper tray 2, is specified in the paper size
of the data.
The tray in which unsupported paper size is
loaded is selected for duplex printing.
Unsupported paper size is used for duplex
printing.
2-28
Error Refer
codes to:
5D, 2-54
5E
1E, 2-38
50 2-51
54 2-51
55 2-51
51 2-51
52 2-51
53 2-51
60 2-55
61
62
63
74 2-59
CF 2-90
A5- 2-78
BF 2-85
59 2-53
5B 2-54
97 2-74
98 2-74
99 2-74
89 2-68
Confidential