Brother DCP-9055CDN Service Manual page 259

(5) Fold the Second side CIS harness at the position 200 mm away from the Second side
scanning CIS side.
Fold down FFC along with the solid line
Reinforcement tape
(6) Align the Second side CIS harness to the angle of the Rib of the FFC holder ASSY and
pass it through the FFC holder ASSY as shown in the figure below, and then affix it to the
double-sided adhesive tape affixed to the FFC holder ASSY.
FFC holder ASSY
Second side CIS harness
Second side CIS harness
200 mm
Fig. 3-92
Pass the harness through here.
Fig. 3-93
3-78
Rib (Align the folded area to this part.)
Second side CIS harness
Reinforcement plate
FFC holder ASSY
Affix it to the double-sided
adhesive tape.
Confidential