Log Set Installation - Regency P121-NG Owners & Installation Manual

LOG INSTALLATION
Read the instructions below carefully and refer to the diagrams. If
logs are broken do not use the unit until they are replaced. Broken
logs can interfere with the pilot operation.
Log Kit # 360-930 contains the following pieces:
a) 326 Front Right Log
b) 327 Front Left Log
c) 328 Middle Right Log
d) 329 Middle Left Log
e) Embers
Please note that there are 2 of each log. This log
set is mirrored front and back.
327
329
The 3-digit numbers (ie. 327) are
molded into the rear of each log.
The image below shows all of the logs in place.
328
327 329
®
Regency P121/P121LC/P121RC/P131 Zero Clearance Room Sealed Gas Fireplace
902-154
326
328
326 329
326 328
1) Carefully remove the logs from the box and unwrap them. The logs
are fragile, handle with care - do not force into position.
2) Place Log 326 on the front right side of the burner. Ensure that the
notches on the far right side of the log fi t into the grate posts. Push back
side of the left end of the log up against the tab on the burner.
Push back side of the left end of the log up
Repeat step 2 on the opposite side of the burner.
3) Place Log 327 on the front left side of the burner. Position the right
327
end of the log in between the two tabs and the left end of the log into
the grate post.
INSTALLATION
326
against the tab on the burner.
326
326
327
Tab on Burner
Grate Post
25