Framing And Finishing - Regency P121-NG Owners & Installation Manual

Zero clearance room sealed gas fireplace

Hide thumbs

Table Of Contents

Table of Contents

INSTALLATION

1) For ease of installation, frame your ﬁ replace after it is positioned and

the ﬂ ue system is installed. Remember to install the top standoffs.

See page 11 for assembly. Use 2x4's and frame to local building

codes.

CAUTION: Verify your ﬁ replace dimensions, framing methods and

ﬁ nished wall facing details before framing. Determine the total

thickness of facing material - drywall plus ceramic tiles, slate, etc.

Allow the ﬁ nish surface to be ﬂ ush with the front or side of the

unit. Total facing thickness can vary from 1/2" (13mm) to 1-1/4"

(32mm) thick.

2) When locating your appliance on an exterior wall or in a chase, apply

a vapour barrier and drywall, as per local building codes. DO NOT

INSULATE THE FIREPLACE ITSELF.

CAUTION: The unit does not have to be completely enclosed in a

chase. The clearance on top of the unit is 0" to the standoffs so

combustible building materials can be laid directly on top of the

standoffs. You must maintain clearance from the ﬂ ue to combustible

materials for both rigid and ﬂ ex, see Flue Clearances, page 9.

P121 - See Thru

P131 - Pier

Note: These units are

non-load bearing.