Connecting To The Ethernet Interface - Ricoh Laser Printers Network Manual

Connecting the Network Cable to the Network
Connecting to the Ethernet
Interface
The network interface board supports
10BASE-T or 100BASE-TX connec-
tions.
A
2
Turn off the main power switch.
Important
❒ Make sure the main power is
off. See "Turning On the Pow-
er", Copy Reference.
B
Loop the network interface cable
and attach the ferrite core.
Note
❒ The network interface cable
loop should be about 10 cm
(4")(A) from the end of the ca-
ble (closest end to the printer).
The ferrite core at the end of the
cable should be a ring type.
6
C
Connect the network interface ca-
ble to the 10BASE-T/100BASE-TX
port.
D
Turn on the main power switch.
1.
Indicator (green)
Remains green when the machine is
properly connected to the network.
2.
Indicator (yellow)
Turns yellow when 100 BASE-TX is
operating. Turns off when 10 BASE-T
is operating.
AAW026S1
1.
2.
AAW022S1
ARL008S