Cleaning Burner Assembly; Non-Stick Surface Care And Use - Thermos 4656110 Assembly Manual

Clean burner prior to use after storing, at the beginning of grilling season or a
•
period of one month not being used. Spiders and insects like to build nests in
burner tubes (especially during colder months). These nests can cause fires
in burner tubes or under grill.
• See following pages for specific instructions.
Cleaning the Burner Assembly.
1. Turn gas off at control knobs and LP tank.
2. Remove cooking grate.
3. Remove Regulator/Valve from grill.
4. Clean outside of burner with soap and water. Open clogged holes with a thin wire.
Examine holes. Due to normal wear and corrosion some holes may become
enlarged. If any large cracks or holes are found replace burner. Burner can be cleaned
either installed or removed.
5. If grill is to be stored, coat burner lightly with cooking oil. Wrap in protective cover to
keep insects out.
6. Replace cooking grate.
VERY IMPORTANT: Before cooking again on grill, follow Burner Flame Check.

Non-stick Surface Care and Use.

• Use only plastic tools.
• Do not cut food on surface.
• Do not put pots or pans on surface.
• Do not leave lid down for more than 10 minutes without food on the grill.
Non-stick surface may be damaged.
CA UTION CA CA UTION UTION UTION
CA CA UTION
Typical spider webs inside burner
Grill2GO • 19