Adjustment - Kenwood TK-8180 Service Manual Supplement

TK-8180
Controls
Power Volume
switch Up/Down key
Modular Programmable
MIC jack function keys
Panel Test Mode
■ Test mode operation features
This transceiver has a test mode. To enter test mode,
press [A] key and turn power on. Hold [A] key until fre-
quency version appears on LCD. Test mode can be inhib-
ited by programming. To exit test mode, switch the power
on again. The following functions are available in test mode.
■ Key operation
Key
Function
[S] Shifts to Panel tuning mode
[A] Function on
[B] MSK 1200bps and 2400bps
[C] Test signaling CH up
[ ]/[ ] Test frequency CH up/down
[ ]/[ ] Volume up/down
[ ] Squelch on/off
[■ ] Narrow/Wide 4k/Wide 5k
Microphone key
[PTT] Transmit
[0] to [9] Use as the DTMF keypad.
and [A], If a key is pressed during
[B], [C], transmission, the DTMF
[D], [#], corresponding to the key
[✳] that was presses is sent.
16

ADJUSTMENT

Channel
LCD Up/Down key
"FNC" not appears
Display
-
"FNC" appears
2400bps : icon appears
Signaling No.
Channel No.
-
Narrow : "n",
Wide 4k : "s",
Wide 5k : "w"
-
-
Key
Function
[S] High power / Low power
[A] Function off
[B] Compander on/off
[C] Beat shift on/off
[ ]/[ ] Function off
[ ]/[ ] Function off
[ ] Squelch level 0
[■] LCD all lights
Microphone key
[PTT] Transmit
[0] to [9] Function off
and [A],
[B], [C],
[D], [#],
[✳]
Notes :
• If a [S], [A], [B], [C] key is pressed during transmission, the
DTMF corresponding to the key that was pressed is sent.
• The "Wide 4k" can not use, please skip it.
• LED indicator
Red LED Lights during transmission.
Green LED Lights when there is carrier.
• Sub LCD indicator
"FNC" Appears at function on.
• LCD display in panel test mode
n 1
n : Narrow
Channel No.
s : Wide 4k
w : Wide 5k
"FNC" appears
Display
Low : icon appears
-
On : icon appears
On : icon appears
-
-
On : icon appears
LCD all point appears
-
-
– 1
Signaling No.