Maintenance And Adjustment - Kenwood TS-711A Instruction Manual

Antenna
TS-711A/E
12V
Use short heavy leads
Battery
Fuse should be as close to the battery Fuse
terminal as possible
Turn POWER switch OFF
before connecting/
disconnecting the power cord
MAINTENANCE AND ADJUSTMENT
@ BEEP SOUND VOLUME ADJUSTMENT @ TO MONITOR YOUR CALL SIGN
Remove 8 screw from the top cover and remove the cover.
When the optional call sign display is connected, your call
By adjusting VR1 (yellow) on sign can be monitored when transmitting.
the control unit, the require
audio volume can be ob-
tained.
@ MAIN DIAL TORQUE ADJUSTMENT
Adjust the torque adjusting
screw on the bottom cover
with a (—) head screwdriver.
Turning the screw clockwise
increases drag and counter.
clockwise decreases it.
20
d UL 1) Remove 8 screws from the transceiver top cover with a
(+) screwdriver and remove the cover.
2) As shown in the figure below, link the terminals marked
Y and X with a jumper wire on the control unit. Use a
low wattage pencil type iron.
VR-1
Note:
When transmitting with this jumper wire connected, noise may be
observed. If so, remove the jumper.