Adjusting/Setting Items After Board Replacement; Service Action After Replacing The At-155B; Board; Service Action After Replacing The Lithium Battery On The At-155B Board - Sony CCU-590 Maintenance Manual

3-3. Adjusting/Setting Items after Board
Replacement
After the lithium battery on the AT-155B board replace-
ment or the plug-in board replacement, be sure to perform
the following adjustment and setting.
3-3-1. Service Action after Replacing the AT-
155B Board
Adjusting/Setting
2-5-3. Adjusting the Phases of the Signals
. Adjusting the phase of the sync signal
. Adjusting using the AT-155B board of CCU-590/
590P
. Adjusting the phase of the camera signals
. Setting the SERIAL No. on "C15" page of the
CCU CONFIGURATION menu.

3-3-2. Service Action after Replacing the

Lithium Battery on the AT-155B Board
Adjusting/Setting
Check DATE/TIME on page "C13" of the CCU CONFIG-
URATION menu, and re-set it if necessary.
3-3-3. Service Action after Replacing the AU-

295 Board

Adjusting/Setting
2-2-1. Settings for the Intercom Systems
. Setting and adjusting the intercom system
. Setting and adjusting the program audio signal
. Setting and adjusting the intercom line connected
to INCOM connector
2-2-2. Setting the Program Microphone Signal
. Setting the output level of microphone
2-3-1. Setting for the Tally System
CCU-590/P/V1(E)
3-3-4. Service Action after Replacing the
DM-140 Board or IV-57B Board
Adjusting/Setting
2-4-5. Adjusting the Triax Signal
. Setting the cable compensation
. Adjusting the black level of camera signal
3-3-5. Service Action after Replacing the EN-
156B Board
Adjusting/Setting
2-4-1. Selecting the Input/Output Signal
2-4-4. Adjusting the VBS Signal Level
2-4-6. Adjusting the Level of the Signals for a Wavefrom
Monitor
2-4-7. Adjusting the Level on a Picture Monitor
2-4-8. Adjusting the G/Y, B/B-Y, R/R-Y Signal Level
3-9