Storing The Settings Of A Wipe, Pip, And Setting Menu Items - Sony BRS-200 Operating Instructions Manual

Storing the Settings of a Wipe, PIP, and Setting Menu
Items
You can store the settings of a wipe, PIP (picture-in-picture), and setting menu
items in the registers of the switcher and recall them as required.
There are three registering functions:
Function Setting items to be
registered
Snapshot Setting data on setting
menu pages 400 to 850
Direct wipe Wipe pattern
Direct PIP Size and display
position of the
embedded video for PIP
Notes
• A snapshot register can store all the data on setting menu pages 400 to 850
with the exception of the date setting on menu page 440.
• Use the snapshot function to store the setting items for PIP that cannot be
stored with the Direct PIP function, such as the cropping data (page 79).
Numeric buttons
1
Set the items you wish to store, as required.
• To store snapshot data, perform settings on menu pages 400 to 850
referring to "Preparations" in Chapter 3 or "Menu List" in Appendix.
• To store wipe patterns, see "Switching the Video with a Wipe" on page
72.
• To store the size and display position of PIP video, see "Adjusting the
Size and Display Position of an Embedded Video in Picture-in-Picture"
on page 77.
2
Check that the SW mode button is lit.
When the SW mode button is not lit, press to light up the button to set the
switcher to SW mode.
3
Check that "DIRECT" is displayed on the display panel above the F3
control.
Register numbers
Snapshot numbers 0
to 99
Direct wipe numbers
0 to 9
Direct PIP numbers 0
to 9
7 8 9
MENU
DSK PIP SETUP
DIRECT
4 5 6
RECALL
MEM WIPE MATT
1 2 3
PRESET
0 .
CLEAR RECALL
MENU/SNAP SHOT/CAMERA POSITION

Storing the Settings of a Wipe, PIP, and Setting Menu Items

Maximum
number of
registers
100
10
10
DIRECT RECALL button
PRESET button
RECALL button
97