Data Group Characters - PSC QuickScan QS6500 Reference Manual

Data Group Characters

Options are available to insert characters in up to four positions between
the scanned bar code data. This is accomplished by selecting the position
and up to 22 ASCII characters for each for Data Group 1, Data Group
2, Data Group 3 and Data Group 4 settings.
The options in this chapter set Data Group Characters
globally for all symbologies. If you wish to enable this
feature only for a single symbology, turn to the options
for that symbology in the
NOTE
Example: Setting Position and Characters for Data Group 1
In this example, we'll set a positon and select two characters for Data
Group 1.
Select Data Group 1 Position
1. Determine which position in the bar code data you wish to insert
character(s). In this example, we'll select a position three characters
from the left within the bar code data.
Make sure the insertion position you select is not
greater than the total number of bar code characters
scanned; otherwise, the Data Group character(s) will
not be inserted.
NOTE
2. Scan the START bar code.
3. Scan the SET DATA GROUP 1 POSITION bar code.
4. In this step, we select the three-spaces-from-the-left position in
which to place the characters we'll select later. Scan first the 0
(zero) bar code, then the 3 bar code from the numeric digit bar
codes provided in
5. Scan the SET bar code to accept the digits scanned.
6. Scan the END bar code to exit Programming Mode.
Select Data Group 1 Character(s)
1. Determine which ASCII character(s) is/are to be added to scanned
bar code data. In this example, we'll add two characters: + (the plus
sign) and # (the pound, or number sign).
Product Reference Guide
Symbologies
Appendix B, Alpha-Numeric Pad
Data Editing Overview
chapter.
.
5-11