RS-232 Interface Features — cont.
ACK NAK Timeout Value
START
MODE
This item specifies the time the imager will wait for an
ACK character from the host following a label trans-
mission.
0 = Infinite timeout
1 - 75 = Timeout in 200-millisecond increments
To configure this feature, scan the "START" bar code
above to place the unit in Programming Mode, then
the "Set ACK NAK Timeout Value," followed by the
digits from the Alphanumeric table in
Alpha-Numeric Pad
value. Accept your selection by scanning the "SET"
bar code below and finally, exit programming mode
by scanning the "END" barcode below
Set ACK
NAK Timeout
Value
SET
END
Product Reference Guide
BARCODE
DEFAULT SETTING FOR THIS FEATURE: 01
Appendix B,
representing your desired
Interface Features
4-21