Nak Character - PSC QuickScan QS6500 Reference Manual

RS-232 Interface Features — cont.

NAK Character

START
MODE
Sets the NAK character from the set of ASCII charac-
ters or any hex value from 0 to FF. To configure this
feature, scan the "START" bar code above to place
the unit in Programming Mode, then the "Set NAK
Character," followed by the digits from the Alphanu-
meric table in
representing your desired character. Accept your
selection by scanning the "SET" bar code below and
finally, exit programming mode by scanning the
"END" barcode below.
DEFAULT SETTING FOR THIS FEATURE: 21 (0x15)
Set NAK
Character
SET
END
Product Reference Guide
BARCODE
Appendix B, Alpha-Numeric Pad
Interface Features
4-19