Ack Nak Retry Count - PSC QuickScan QS6500 Reference Manual

Interface Related Features
RS-232 Interface Features — cont.

ACK NAK Retry Count

START
MODE
This feature sets the number of times for the imager
to retry a label transmission under a retry condition.
0 = No retry
1 - 254 = Retry for the specified number of times
255 = Retry forever
To configure this feature, scan the "START" bar code
above to place the unit in Programming Mode, then
the "Set ACK NAK Retry Count," followed by the dig-
its from the Alphanumeric table in
Alpha-Numeric Pad
count. Accept your selection by scanning the "SET"
bar code below and finally, exit programming mode
by scanning the "END" barcode below
Set ACK
Nak Retry
Count
SET
END
4-22
BARCODE
DEFAULT SETTING FOR THIS FEATURE: 03
Appendix B,
representing your desired retry
®
QuickScan QS6500/QS6500 BT