Mounting; Orientation; Standard Hanging - Chauvet MotionOrb User Manual

3. Setup
Rig the product from a structure or surface that can support its weight. See

Mounting

Technical Specifications in this manual for the product's weight.
Always use a mounting clamp and safety cable when mounting the product overhead. The
CHAUVET® CLP-15 clamp fits into the two M12 mounting holes and the CHAUVET® CLP-10
clamp fits into the three M10 mounting holes. The CHAUVET® CH-05 safety cable fits through
the safety loop.
For the CHAUVET® line of mounting clamps, go to www.chauvetlighting.com/cables-clamps-
main.html/.
Make sure that the structure onto which the product is mounted can support the product's
weight. For weight information, see Technical Specifications.
Hang the MotionOrb™ by attaching the top bar a to pipe or truss with mounting clamps so the

Orientation

orbs strings hang straight down or are be draped up with the bottom loops tied off to another
structure.
Place the MotionOrb™ so that the top bar is accessible for programming and control panel
operation.
Safety Cable
Mounting Clamps
Safety Loop
Standard
Hanging
MotionOrb™ User Manual Rev. 1 Page 15 of 96