Setup; Ac Power; Fuse Replacement; Fuse Replacement Diagram - Chauvet MotionOrb User Manual

3. Setup

3. S
ETUP
The MotionOrb™ has an internal auto-ranging power supply that works with an input voltage

AC Power

range of 100 to 240 VAC, 50/60 Hz.
To determine the product's power requirements see the product label, or refer to
Technical Specifications in this manual. The listed current rating indicates the product's average
current draw under normal conditions.
For more information, download Sizing Circuit Breakers from the CHAUVET® website:
www.chauvetlighting.com/download/.
Always connect the product to a protected circuit.
Never connect the product to a rheostat or dimmer.
To replace the fuse, do the following:
Fuse
1. Disconnect the product from power.
Replacement
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the fuse holder out of the housing.
4. Remove the blown fuse from the holder.
5. Insert a fuse of the exact same type and rating.
6. Replace the fuse holder back into the slot.
7. Reconnect the product to power.
Installed Fuse
(held by plastic clip)
Spare Fuse
Fuse
Safety Cap
(not included)
Replacement
Diagram
Spare Fuse Holder
(inside safety cap)
· Disconnect the product from power before replacing the fuse.
· Always replace a blown fuse with another of the same type and rating.
· A spare fuse is not included; however, the safety cap has room for one.
MotionOrb™ User Manual Rev. 1 Page 11 of 96