Fostex DV40 Operation Manual page 176

3. While "Sure?" flashes, press the [ENTER/YES] key.
If the file is successfully divided, "Completed!" will be displayed.
4. Register the next SOURCE IN and OUT points and repeat the procedures 1. ~ 3.
The divided files will be named in numerical serial sequence. "V01", "V02", etc. will be attached at the
head of the file name. If you would like to change the file name, rename it by using "Edit File Name?"
in the UTILITY menu.
The following example shows that the file "Take" has been divided into 2 (two) separate files.
LTC IN
H
The above display indicates that the 1st file is
divided by the section from 01H 00M 00S 00F to
03H 20M 38S 26F and its file number is 005.
<NOTE>
The divided files are set to the RECORD PROTECT: ON condition. You cannot record to these files.
Even if you manually cancel the RECORD PROTECT: ON condition and try to record to these files,
the DV40 will display a " Common File! " message and the RECORD operation will be invalid.
Deleting Divided Files
Please follow the procedures below to delete divided files.
<NOTE>
READ ONLY operation is all that is possible on divided files that have been exported to a PC.
Do not try to cancel the RECORD PROTECT flag in the file and delete it on a PC.
1. Recall the divided file you would like to delete.
2. Change the "Rec Protect?" UTILITY menu setting from "On" to "Off".
Refer to the original owner's manual for operation of the "Rec Protect?" UTILITY menu feature.
3. Delete the divided file by the "Delete File?" UTILITY menu.
Refer to the original owner's manual for operation of the "Delete File?" UTILITY menu feature.
4. Optimize the disk by the "Optimize Disk?" UTILITY menu.
Refer to the original owner's manual for operation of the "Optimize Disk?" UTILITY menu feature.
Model DV40 Owner's Manual <Version V1.3 Supplement>
M S F
PGM
LTC IN
H
The above display indicates that the 2nd file is
divided by the section from 03H 20M 38S 26F to
REC END point and its file number is 006.
7
M S F
PGM