Fostex DV40 Operation Manual page 160

DV40 Owner's Manual (Version V1.2 Supplement>
• Editing Description information
1. Select a line to be edited and press the [ENTER/YES] key.
The example below indicates that the 6th line is selected. The display changes to the condition that
the left end of the currently recorded Description information starts flashing.
2. Press the [SKIP/CURSOR>>|] key and move the flashing cursor to the right of "TRK1=" and edit the
"********" section.
3. Input a new information by the JOG dial (or 10 key).
• Input by the JOG dial
The flashing point can be moved to the right after inputting and then pressing the [SKIP/CURSIR
>>|] key.
• Directly input by the 10 key
The flashing points moves every time a different 10 key is pressed. ([SKIP/CURSOR >>|] can be used
as well.)
4. After inputting a new information, press the [ENTER/YES] key.
Input information is recorded and the display changes to the line number flashing condition.
5. In order to edit other lines, repeat the above procedures 1 ~ 4.
• Addition of Descriptor information line
1. While the number of line is flashing, rotate the JOG dial fully C.W.
"<New Line>" is displayed and a newly created line number flashes.
2. After pressing the [ENTER/YES] key, by the same manner as explained in the above section "Editing
Description Information", input the information by the JOG dial (or 10 key) and press the [ENTER/
YES] key again.
<NOTE>
When adding a line, you must input the meta data header ID and then input data.
Flashing
Flashing
26
Flashing
Flashing