Fostex DV40 Operation Manual page 101

Tips:
You can monitor the track data copied to the clipboard using the SOURCE-PLAY function before carry-
ing out the insert operation. See "Tips: SOURCE-PLAY" on page 10-3.
5. Use the jog dial to select "Clip Insert?" and press the [ENTER/YES] key.
"Sel.Insert TRK?" appears on the display, in which you can select the destination track(s) to be inserted.
If you select a single track as a copy source, you can select the same or a different track as a destination. If
you select 2 or 4 tracks as copy sources, the destination are restricted to the same tracks.
6. If you select a single track as a copy source, select a destination track for insert by pressing the
appropriate edit point keys (as step 4) and press the [ENTER/YES] key.
If you select 2 or 4 tracks as copy sources, simply press the [ENTER/YES] key again.
"Clip Insert" is shown with flashing "Sure?".
7. Press the [ENTER/YES] key again.
The unit starts inserting the copied track data on the clipboard to the specified track(s) from the "DEST IN"
point. The display shows the required time together with the achieved percentage for insert.
The time is counted down while the percentage is counted up as the insert operation is in progress.
Also, the status is graphically shown by the track 1 level indicators which gradually light up from left to
right. When all the data is inserted, "Insert Completed!" is shown and the unit stops.
8. Press the [EXIT/NO] or [STOP] key repeatedly to exit the AUDIO EDIT mode.
Tips:
If you are not satisfied with the result, you can undo the insert operation.
Flashing
Flashing
REMAIN
H M S
1
2
∞
60 50 42 34 28 2018 12 8
6 5 4 3 2 1 0 OL
REMAIN
H M S
1
2
∞
60 50 42 34 28 2018 12 8 6 5 4 3 2 1 0 OL
10-5
Flashing
%
BIT
24
FS
48
kHz
CLOCK
-0.1%
-INT-
FORMAT
BWF
%
BIT
24
FS
48
kHz
CLOCK
-0.1%
-INT-
FORMAT
BWF
Flashing
Flashing