Pioneer PRO-200 Service Manual page 53

E
If IQ SELECTOR ASSY
If COMPONENT ASSY
If OTHER ASSY
Note (∗1):
For the adjustment of the steps 2,3,13 and 14, both adjustments of composite video signal and the component video signal is necessary.
• When the adjustment of the composite video signal is performed.
1. Input the COMPOSITE VIDEO signal to the VIDEO INPUT terminal.
2. Switch the video to the input of the composite video signal.
3. Perform the adjustment in accordance with the directions of the steps 2,3,13 and 14.
• When the adjustment of the component video signal is performed.
1. Input the COMPONENT VIDEO signal to the DVD COMPONENT VIDEO INPUT terminal.
But, when the adjustment of the color is not performed (steps 2, 3, 13, 14-1 and 14-2),
you may input the signal (without color burst and chroma) which took out Y signal from the composite signal to the Y input of component.
2. Switch the video to the input (LD/DVD) of the component video signal.
3. Perform the adjustment in accordance with the directions of the steps 2,3,13 and 14.
But, for the part with the directions of pressing the
Note : Be sure to adjust the composite video signal first.
is repaired
20
is replaced
2
3
is repaired or replaced
13 11
14 14
is repaired or replaced
(DOWN) button, press the SWAP button to the substitute.
PRO-200, PRO-100
CINEMA MUTE adjustment
No adjustment is required
Contrast coarse adjustment
Perform the adjustment of
Brightness adjustment
only component video signal.
White balance adjustment
Refer to the "Note (∗1)" as follows.
PIONEER's standard settings
No adjustment is required
original page 133
53