Pioneer PRO-200 Service Manual page 52

PRO-200, PRO-100
Assembly Adjustment Location Guide
Attention: A point to give a
D
If POWER SUPPLY ASSY
If TUNER • VIDEO ASSY
B
Reset the other items such
as the tuner preset channels,
convergence, etc. which
should be set by the user.
C
If TUNER 2 ASSY
If CONVERGENCE ASSY
If R, G or B CRT DRIVE ASSY
A
If P IN P ASSY
If CRT ASSY
If LENS ASSY
If 3D Y/C ASSY
52
mark has just become a change toward the PRO-119 and PRO-99.
is repaired
is replaced
the video block
the UCOM block
the tuner block
the audio block
is replaced
is repaired or replaced
is repaired or replaced
is repaired or replaced
is repaired
is replaced
R, G, B or deflection yoke is replaced
is replaced
is repaired or replaced
1
135V power supply adjustment
7
Focus VR adjustment
8
Vertical size adjustment
9
Horizontal size adjustment
10 Convergence adjustment
13
White balance adjustment
8 Vertical size adjustment
9 Horizontal size adjustment
Convergence adjustment
10
White balance adjustment
13
3 Brightness adjustment
White balance adjustment
13
PIONEER's standard adjustment
14
2 Contrast coarse adjustment
3 Brightness adjustment
Test-cross H-center position adjustment
11
PIONEER's standard settings
14
Tuner block adjustment
12
No adjustment is required
All the above adjustments except for the test-cross H-center
position adjustment and tuner adjustment are required.
Video level adjustment
12 -2 2
Convergence adjustment
10
White balance adjustment
13
Y-signal level adjustment of sub-picture
15
TINT adjustment of sub-picture
16
Color level adjustment of sub-picture
17
18 Write clock adjustment
19 Read clock adjustment
No adjustment is required
4
Deflection yoke lean adjustment
5
Screen center adjustment
7 Focus VR adjustment
10
Convergence adjustment
13
White balance adjustment
14
PIONEER's standard settings
6 Focus adjustment of lens assy
Convergence adjustment
10
Check white balance. If the best screen is not obtained, adjust
White balance adjustment.
13
Refer to the
"Note (∗1)" as follows.
Refer to the
"Note (∗1)" as follows.
Refer to the
"Note (∗1)" as follows.
Refer to the
"Note (∗1)" as follows.
Refer to the
"Note (∗1)" as follows.
Refer to the
"Note (∗1)" as follows.
Refer to the
"Note (∗1)" as follows.
original page 133