Fujitsu LTO-6 User Manual page 50

Troubleshooting
Error Cause and Action
Code
"P" Write operation to a write protected cartridge has been
attempted (this includes any attempt to overwrite a WORM
protected tape). Ensure the tape cartridge is the correct media type.
Writes to Ultrium-1, Ultrium-2, Ultrium-3, and Ultrium-4 tape
cartridges are not supported in the LTO-6 Tape Drive. If the tape
cartridge is the correct media type, check the write-protect switch on
the cartridge. The drive will not write to a write-protected cartridge.
The error code clears when you remove the tape cartridge.
"J" Incompatible media was used. The tape drive detected an
unsupported cartridge was loaded or the cartridge loaded has an
incompatible format. Ensure the tape cartridge is the correct media
type.See
"u" Firmware update is in progress. The drive is in the prosess of
uploading and flashing Firmware.
I
Figure Mid-tape Recovery. Drive is recovering from power cycle with tape
"8" in drive. The figure "8" is broken up with a countdown indicating
progress in ten's percentage to completion (9,8,7,6,5,4,3,2,1).
Please wait until mid tape recovery ends.
Table 7: Error codes on the Single-character Display
50
"Cartridge Compatibility" on page
Do not power cycle the server.
36.
LTO-6 Half-Height SAS Tape Drive