Operation Panel Frequency Setting/Key Lock Operation Selection (Pr. 161) - Mitsubishi Electric FR-D700 Instruction Manual

4.22.3 Operation panel frequency setting/key lock operation selection (Pr. 161)

The setting dial of the operation panel can be used for setting like a potentiometer.
The key operation of the operation panel can be disabled.
Parameter
Number
Frequency setting/key lock
161
operation selection
The above parameters can be set when Pr. 160 Extended function display selection = "0". (Refer to page 157)
(1) Using the setting dial like a potentiometer to set the frequency.
Operation example Changing the frequency from 0Hz to 50Hz during operation
Operation
1.
Screen at powering on
The monitor display appears.
2.
Press to choose the PU operation mode.
3.
Press to choose the parameter setting
mode.
4.
Turn until
5.
Press to read the currently set value.
" "(initial value) appears.
6.
Turn to change it to the set value "
7.
Press to set.
8.
Change Pr. 161 to the setting value of "
in the similar manner. (Refer to step 4 to 7.)
9.
Mode/monitor check
Press twice to choose the monitor/
frequency monitor.
10.
Press to start the inverter.
11.
Turn until "
The flickering frequency is the set frequency.
You need not press
Setting from the parameter unit and operation panel
Name Initial Value
(Pr. 160) appears.
".
"
" appears.
.
Setting
Range
Setting dial frequency
0
setting mode
Setting dial
1
potentiometer mode
0
Setting dial frequency
10
setting mode
Setting dial
11
potentiometer mode
PU indication is lit.
PRM indication is lit.
(The parameter number read previously
appears.)
Flicker Parameter setting complete!!
Flicker Parameter setting complete!!
The frequency flickers for about 5s.
Description
Key lock mode invalid
Key lock mode valid
Display
4
235