Mitsubishi Electric FR-D700 Instruction Manual page 167

(3) Operation mode selection flow
In the following flowchart, select the basic parameter setting and terminal connection related to the operation mode.
START
Where is the start command
source?
From outside
(STF/STR terminal)
Where is the frequency
command source?
From outside
(Terminal 2, 4,
JOG, multi-speed, etc.)
From PU
(digital setting)
From communication
(PU connector (RS-485
communication))
From the operation panel
(RUN/FWD/REV key)
Where is the frequency
command source?
From outside
(terminal 2, 4, JOG,
multi-speed, etc.)
From the operation panel
From communication
(PU connector (RS-485 communication)
From communication
(PU connector (RS-485 communication))
Where is the frequency
command source?
From outside
From the operation panel
From communication
communication))
Selection of operation mode and operation location
Connection
STF (forward rotation)
/STR (reverse rotation)
(Refer to page 108.)
Terminal 2, 4-5 (analog), RL, RM,
RH, JOG, etc.
STF (forward rotation)
/STR (reverse rotation)
(Refer to page 108)
STF (forward rotation)
/STR (reverse rotation)
(Refer to page 108)
Terminal 2, 4-5 (analog), RL, RM,
RH, JOG, etc..
(digital setting)
Disabled
(terminal 2, 4, JOG, multi-speed, etc.)
Terminal 2, 4-5 (analog), RL, RM,
RH, JOG, etc.
(digital setting)
(PU connector (RS-485
Parameter setting
Frequency setting terminal ON
Pr. 79 = "3"
Operation panel, PU digital setting
(External/PU combined
operation 1)
Communication frequency setting
Pr. 338 = "1"
Pr. 340 = "1"
Pr. 79 = "4"
Frequency setting terminal ON
(external/PU combined
RUN/FWD/REV key ON
operation 2)
Pr. 79 = "1"
(fixed to PU operation) RUN/FWD/REV key ON
Frequency setting terminal ON
Pr. 339 = "1"
Communication start command
Pr. 340 = "1"
Disabled
Communication frequency setting
Pr. 340 = "1"
Communication start command
Operation
STF(STR)-ON
STF(STR) ON
command sending
STF(STR)-ON
Digital setting
sending
command sending
sending
4
163