Using System Functions From Outside Disa (Direct Inward System Access) - Siemens HiPath 500 Operating Instructions Manual

Hide thumbs Also See for HiPath 500:
Table of Contents

Advertisement

Step by Step
Using system functions from outside
DISA (direct inward system access)
If configured (contact your service personnel), you can
use an external phone like an internal station to set up
an outgoing external connection via the system. You
can also activate or deactivate the following system
functions:
Reset services and functions,
code #0
Call forwarding, code
Lock and unlock phone,
code
66/#66
*
Save your PIN,
code
93
*
Send a message,
code
68/#68
*
Leave an advisory message,
code
69/#69
*
Ringing group, code
Group call, code
Caller ID suppression,
code
86/#86
*
Camp-on tone, code
Open door, code
Release door opener, code
Control relays, code
Do not disturb, code
Ringer cutoff, code
Dial using speed dial, code
Associated service, code
Prerequisite: Your phone supports tone dialing (DTMF)
or you can switch your phone to tone dialing. The phone
is not connected to the system.
j
Establish a connection to the system. Enter the station
number (contact your service personnel).
j
Wait for the continuous tone (if necessary, switch pho-
ne to tone dialing) and enter the internal number assig-
ned to you and the corresponding PIN.
(
Enter the code (only required if programmed in the sys-
tem).
More functions/services
page 91
1/#1
*
page 81
page 83
page 85
page 87
81/#81
*
85/#85
page 108
*
page 78
87/#87
*
61
page 45
*
89/#89
*
90/#90
*
97/#97
*
98/#98
*
7
*
83
*
page 38
page 108
page 57
page 46
page 97
page 77
page 77
page 52
page 92
93

Advertisement

Table of Contents
loading

Table of Contents