Using System Functions From Outside Disa (Direct Inward System Access) - Siemens HiPath 500 User Manual

More functions/services
Step by Step
72
Using system functions from outside
DISA (direct inward system access)
If configured (contact your service personnel), you can
use an external phone like an internal station to set up
an outgoing external connection via the system. You
can also activate or deactivate the following system
functions:
• Reset services and functions,
code #0
• Call forwarding, code
• Lock and unlock phone,
code 66/#66
*
• Save your PIN,
code 93
*
• Send a message,
code 68/#68
*
• Leave an advisory message,
code 69/#69
*
• Ringing group, code
• Group call, code
• Caller ID suppression,
code 86/#86
*
• Camp-on tone, code
• Open door, code
• Release door opener, code
• Control relays, code
• Do not disturb, code
• Ringer cutoff, code
• Dial using speed dial, code
• Associated service, code
Prerequisite: Your phone supports tone dialing (DTMF)
or you can switch your phone to tone dialing. The phone
is not connected to the system.
j
Establish a connection to the system. Enter the station
number (contact your service personnel).
j
Wait for the continuous tone (if necessary, switch pho-
ne to tone dialing) and enter the internal number assig-
ned to you and the corresponding PIN.
(
Enter the code (only required if programmed in the sys-
tem).
page 70
1/#1
*
page 61
page 63
page 65
page 67
81/#81
*
85/#85 page 78
*
page 59
87/#87
*
61 page 34
*
89/#89
*
90/#90
*
97/#97
*
98/#98
*
7
*
83
*
page 27
page 78
page 46
page 35
page 76
page 58
page 57
page 41
page 71