Draytek Vigor 2130 Series User Manual page 236

A d d i n g a V P N T u n
A d d i n g a V P N T u n
Click Add Tunnel to open the following page.
Enabled
Always On
Name
Remote IP
User Name
Password
MPPE
Local Network / Mask
Remote Network / Mask
Change default route to
this VPN tunnel
PPTP Dial-in Tunnel
Click OK to save the settings.
n e l f o r P P T P
n e l f o r P P T P
Check here to activate this tunnel.
Check this box to make the WAN connection being activated
always.
Specify a name for this tunnel.
Enter the IP address/name of the remote host that located at
the other-end of the VPN tunnel.
Type a name for this tunnel for authentication.
Type a password for this tunnel for authentication.
Check this box to enable the function of MPPE for such
tunnel.
Traffic between this subnet and the subnet specified in Remote
Network / Mask will travel through the VPN tunnel.
Add a static route to direct all traffic destined to this Remote
Network IP Address/Remote Network Mask through the VPN
connection.
Check this box to change the default route into such VPN
tunnel.
If it is required, click Add Tunnel link to access into VPN
and Remote Access>>PPTP Remote Dial-in page for adding
other dial-in tunnel. Refer to the section 4.8.2 for detailed
information.
226
Vigor2130 Series User's Guide