Installing The Bf84 Logset - Montigo BF52-ST Installation, Operation & Maintenance Manual

f i r e f e a t u r e
Installing the BF84 Log Set
Installing the Logs:
The BF84-ST fireplace is supplied with (9) nine ceramic fibre logs.
Unpack the logs and handle them very carefully.
Note: Utilize the front & rear Logrest stiles as reference. (Reference
lines indicating centre line orientation, and flush end alignment).
Step 1. Remove the glass door as described on Page 15.
9 8
7
6
Linear Burners
1 2
3
4
Place embers in trays
Spread out evenly
Figure. 12 BF84 Grate (Note location of the 9-Tines (front & back)
and Ember tray under Grate.
Step 2. Place the embers in both trays. Spread out evenly to ensure
the flame effect is symetrical. See Step 9 final Log Assembly.
Step 3. Place the two (2) Log labeled "A" . Align with the grate tines
as shown. Note ALL dimensions referencing grate tines are taken
from the center of the Tine. (Note location of knots).
Flat
Knots
Log A
1
5"
Figure. 12a Location of Logs 'A' and embers (Both sides Typical).
Step 4. Place the two (2) Log labeled "B" . Align with the ends of 'A'.
Flush
Log B
Knot
Flat
Figure. 12b Location of Logs 'B' and embers (Both sides Typical).
Part No. XG0711 - 022410
Installation
5 4 3
2 1
8 9
6 7
5
Grate Tines
5"
1
Log A
Knots
Flat
Flush
Flat
Knot
Log B
Step 5. Place the one (1) Log labeled "C" . Align with the grate tines
as shown. Note location and direction of Log "D" oval alignment
cutouts.
2 1/2"
6
Log "D" Oval Cutout
Log C
Figure. 12c. Place the faux Log labelled 'C'. (Note: Align the Log with
the two (2) smooth indents facing upward, and the one (1) charred
indent facing downwards toward the Linear burners). See Figure 12d
& Figure 12e). (Indicated by ovals).
Step 6. Place the two (2) curved Logs labeled "D" . Align with the
grate tines, and oval alignment cutouts as shown. Note: both outer
ends are flush with the grate.
Note location
Log D
of burners
C L
Flush with
4
3
Grate Tines
Figure. 12d Location of Logs 'D' (Log placement Typical for both).
Step 7. Place the two (2) straight Logs labeled "E" . Align with the
grate tines, and hollows (against knot) on Logs "D" as shown. Note:
both outer ends are flush with grate tines.
9
C L
Log E
Flush with
Grate Tines
Place Log E
in hollow, Log D
knot
Figure. 12e Location of Logs 'E' (Log placement Typical for both).
BF-Series-ST Gas Fireplace
Flush with Grate Tines
C L
Log "D" Oval Cutout
Flush with Grate Tines
6
2 1/2"
Flush with
3
4
C L
C L
Grate Tines
C L
Log D
Note location
of burners
C L
Place Log E
in hollow, Log D
knot
Log E
Flush with
Grate Tines
Page 13
C L
9